Agilent Security trunking radios and our 2m repeater system hardware. Our hardware is located toward the top of the two racks.

3 - 220 MHz receivers, to receive from 3 remote 2m-in 220-out repeaters, and the voter that selects the best audio of all inputs.

General Electric 2m receiver, fed from the 2m antenna on the roof, and a spare/unused 2m transceiver.

2m repeater system controller.

The back of the 2 racks shown in first photo.

The controller rear panel is up high, with the orange cable on it. Follow the orange cable lower, to a box turned sideways and not visible from the front of the rack. This is the autopatch.

The rear panels of the 3 220 MHz receivers, the voter, and the on-site 2m receiver.

Antenna cables to the roof. 3 are ours: 2m receive antenna, 220 MHz receive antenna, and 440 MHz transmit antenna -- the uplink to a remote 440-in, 2m-out repeater.

Building 3W, Southwest roof, where our 2m RX, 220 MHz RX, and 440 MHz TX antennas are.

2m RX antenna.

220 MHz RX and 440 MHz TX antennas.